Setup Instructions for the Brett Catch All Net

Catch All Net Assembly Instructions

1. Connect 18 pieces shock-corded poles to fit together as picture 1. Do the same for the remaining 18 pieces shock-corded poles. Be sure to connect the poles tightly and securely.
2. Spread net on the floor as in picture 2.
3. Push the end of one of the assembled poles through the rod pocket starting at the corner of A1 and finishing at the opposite corner of A2 as picture 3. Repeat this procedure using the remaining assembled poles at the corner of B1 and finishing at the opposite corner of B2.
4. Place the pin at the corner of B2 into the end of the assembled pole. By flexing the pole, walk to the opposite corner of B1 and also insert the pin into the end of the assembled pole as picture 4. Repeat this step with the remaining pole and pins at A1 and A2. If there is a helper, have him go inside the Catch All and push up the center for easier placing of the pins to the assembled pole.
5. Position the Catch-All and pull the corners outward to smooth out the floor material. Place one steel ground stake (part no. 3) through the rings at the four corners and finally fix to ground as picture 5.

To disassemble, pull up the steel ground stakes, remove pins from the assembled poles, and push it through the rod pockets.

Attention: Always anchor the Catch All. An unsecured Catch All can fall over.